Help center · Bot commands
Smart sizing and trade rules commands (Tier 2 and 3)
On Tier 2 and 3, /smartSizing and /setSize trade some kinds of signals with a share of your position size, and /tradeRules and /setRule give one kind of trade its own stop or same-coin gap, or switch it off.
Smart sizing
How much of your position size each kind of trade uses. 100% is the full size; 0% skips that kind of trade. Your position size is always the most a single trade uses.
| Command | What it does |
|---|---|
/smartSizing |
Shows your sizes and what they do to your next trades. |
/setSize longs 50 |
Longs use half your position size. |
/setSize strength 2 50 |
Signals of strength 2 use half. |
/setSize Iron 25 |
Signals named Iron use a quarter. |
/setSize Meme 50 |
Coins in Binance's Meme group use half. |
/setSize reset |
Every trade uses your full position size again. |
Shares go from 0 to 100 in steps of 5. They multiply: with longs at 50 and strength 2 at 50, a long of strength 2 uses 25% of your position size. For a coin in several groups, the smallest of their shares counts. A trade that is not skipped never uses less than 5 USDT, the bot's smallest position size. If your sizes would leave the bot trading very little, it says so.
Trade rules
Your own stop, same-coin gap and on/off for one kind of trade. Anything a rule does not set uses your normal settings, and the most specific rule wins.
| Command | What it does |
|---|---|
/tradeRules |
Shows your rules and what they do to your next trades. |
/setRule shorts stop 30 |
Shorts get a 30% stop, whatever /setStopLoss says. stop none means no stop for that kind. |
/setRule short Iron gap 3 |
Short signals named Iron get a 3% same-coin gap. |
/setRule shorts strength 3 off |
The bot skips shorts of strength 3. on trades that kind again. |
/setRule shorts reset |
Clears the rule for shorts. |
/setRule reset |
Clears every rule. |
A rule can be for longs or shorts, a strength (strength 3), a side and a strength (shorts strength 3), a signal name (Iron), or a side and a name (short Iron). A stop goes from 0 to 90%, a gap from 0 to 100%, and you can keep up to 64 rules.
A stop in a rule follows the same safety check as the stop-loss: on isolated margin the bot refuses one that liquidation would always reach first, and it will not raise your leverage past a rule's stop. A stop set in a rule is placed even when /setStopType is OFF.
Both features are in /summary, and /lastsignals says when a signal was skipped or sized by them. The starting point for both is "no change": nothing applies until you set it.
Updated 2026-10-11.
Related
- What commands does the HafizeBot bot have?
- Getting started commands: /start, /setup, /status and /help
- VIP, trial and payment commands
- Commands to switch auto-trading on and off
- Commands for position size, leverage, margin and stop-loss
- Commands that choose which signals the bot trades
Not a member yet? Try VIP free for 3 days, auto-trading included.
Still stuck? Send /support to @hafizebot with your question, or write to [email protected]. Futures trading carries a high risk of loss; nothing here is investment advice.